Supply Of Iet Lab Equipment - in Indore - Complete Tender Details

Supply Of Iet Lab Equipment - Item Name And Specification, Transmission Line Trainer Kit A) Coaxial Cable: 100m (25m * 4) B) Impedance Matching Resistances: 0 - 100 Ohms. 2 Nos. C) Test Generators: 1. Sine Wave: 40 Khz - 400 Khz (low Range) 2. Square Wave: 400 Khz - 4mhz (high Range) D) Interconnections: 4 Mm Banana Sockets E) Test Points: 10, Digital Lcr Meter A) Measurement Function Test Parameter: L-q, C-d, R-q, |z|-q Basic B) Accuracy: 0.2% C) Equivalents Circuit: Series, Parallel D) Range Mode: Auto, Hold Trigger Mode E) Internal Measurement Speed: Fast: 12, Med: 5.1, Slow: 2.5 (meas/sec) F) Correction Function: Open/short Multi Frequency Zeroing Measurement, Digital Multimeter A) 4000 Counts Large Lcd Display With Auto/manual Range B) No Power-off Under Natural Operation C) Data Hold, Max. / Min. Value Hold D) Capacitance, Frequency / Duty Cycle, Temperature And Transistor Test, Digital Storage Oscilloscope 50mhz, 2 Channel A) Real-time Sampling Rate: 500ms/s B) Oscilloscope Storage Depth: 64kpts C) Waveform Capture Rate: 5,000wfms/s D) Auto Measurement: 34 Waveform Types E) Peripheral Interface: Standard Usb Host, Usb Device, Ext Trig, Pass/fail, Digital Communication Lab, Sampling And Reconstruction Module A) Crystal Frequency: 8 Mhz B) Sampling Frequency: 20, 50, 80, 100, 200 & 400 Khz (switch Selectable) C) On-board Generator: Synchronized 1 Khz Sine Wave (5 V) Pp D) Duty Cycle: 0 - 90% In Decade Steps (switch Selectable) E) Low Pass Filters: 2 & 4 Order Butterworth F) Filters Cut-off Frequency: 3.4 Khz Each, Tdm Pulse Code Modulation Transmitter Module A) Crystal Frequency: 16 Mhz B) On Board Analog Signal: 2 Khz, 4 Khz (sine Wave Synchronized C) To Sampling Pulse Adjustable Amplitude And Separate Variable Dc Level) D) Input Channels: 2 Nos. E) Multiplexing: Time Division Multiplexing F) Sync Signal: Pseudo Random Sync Code Generator G) Error Check Code: Off - Odd - Even - Hamming, Tdm Pulse Code Modulation Receiver Module A) Input Channel: Time Division Multiplexed Serial B) Input Demodulation: Pulse Code Demodulation Clock C) Regeneration: By Phase Locked Loop D) Operating Speeds: Fast - 320 Khz/channel, Slow 1.9 Hz/channel E) Error Detection (single Bit): Off-odd-even Parity & Hamming Code F) Error Correction: Hamming Code, Differential Pulse Code Modulation (dpcm) Module G) Functions: Sine And Square H) O/p Frequency Range: 300 Hz To 3.4 Khz I) Audio Blocks: Audio I/p And O/p Processing Circuits J) Control Signals: R/w For Adc, Reset, Latch Enables, Oes K) Sampling Frequency: 8 Khz; Bits Per Sample: 5 Bits Including Sign Bit, Linear Block Code Encoder Module A) Word Length: 4 Bits B) Codeword Length: 7 Bits Code C) Data Format: Nrz (not Return To Zero), Linear Block Code Decoder Module A) Word Length: 4 Bits B) Codeword Length: 7 Bits Code C) Data Format: Nrz (not Return To Zero), Digital Companding A-law & μ-law A) Compression And Decompression Techniques: A-law, ì-law B) Signal Generator: Direct Digital Synthesizer Generated Sine Wave C) 14 Bit Data Input Through Dip Switch. D) Smd Led Indicators: 73nos, For Dip Based Input Data Compressed Output E) Decompressed Output Technique Selection F) Crystal Frequency: 8mhz, Microcontroller Lab, Atmega 32 Chip, Usb Asp Isp Avr Programmer, Male To Male Jumper Wires 40 Pcs, Male To Female Jumper Wires 40 Pcs, Female To Female Jumper Wires 40 Pcs, Breadboards, 5mm Red, Yellow, Green Led (pack Of 10), Rotary Potentiometer 1k Ohm, Resistance, Fixed Resistor, 5 Each, 13 Values (33ohm, 100 Ohm, 220 Ohm, 330 Ohm, 1 Kilo Ohm, 2.2 Kilo Ohm, 3.3 Kilo Ohm, 4.7 Kilo Ohm, 10 Kilo Ohm), Crystal Oscillator 8 Mhz, Capacitor Ceramic (pack Of 25), Rotary Potentiometer 10k Ohm, Mq-02/05, Ir Sensor Module, Pir Motion Detector Hc Sr501, Heartbeat Sensor Module, Ultrasonic Sensor Module, Gyro Sensor, Ldr, Gps, Color Sensor, Ph Sensor, Soil Moisture Sensor, Lm35 Temperature Sensor, Dht11 Temperature And Humidity Sensor, Lcd 16x2, Motors (servo, Dc, Stepper) With Driver Ic, Dc Motor Fan, Iot Lab Item, Raspberry Pi 3 B+, Video Capture Card (for Use In Laptops), Hdmi Cable, Keyboard, Mouse, Esp32, Micro Usb Cable (for Esp 32), Mq-02/05, Ir Sensor Module, Pir Motion Detector Hc Sr501, Heartbeat Sensor Module, Ultrasonic Sensor Module, Gyro Sensor, Ldr, Gps, Color Sensor, Ph Sensor, Soil Moisture Sensor, Lm35 Temperature Sensor, Dht11 Temperature And Humidity Sensor, Lcd 16x2, Motors (servo, Dc, Stepper) With Driver Ic, Dc Motor Fan, Antenna Engineering Lab, Antenna Training Setup With Motorised Rotating Unit Motorised Antenna Unit Plotting Software With 22 Antennas. Micro-controller Based High Precision Dc Stepper Motor. Automatic Zero Point Setting. Built-in Dc Power Supply Instant Plotting Of Radiation Pattern With Antenna & Radar Single User Waveforms: Sine Rf Generator: 750 Mhz Approximately (output Adjustable) Tone Generator: 1 Khz Approximately (output Adjustable) Directional Coupler: Forward & Reverse (selectable) Matching Stub: Slider Type Antenna Rotation: 0-360 Deg. Resolution 1 Deg. Receiving Antenna: Folded Dipole With Reflector Detector Display: Level Adjustable Meter Interconnections: 2 Mm Banana Sockets Product Tutorial